Vocals in the mix
How to make vocals sit in the mix
A vocal that won't sit is usually fighting the beat for the same frequencies, mostly the 2 to 5 kHz range where the words live and the 200 to 500 Hz range where things get muddy. Turning the vocal up only makes it sound pasted on top. The fix is to make a little room in the beat where the voice needs it, keep the vocal's level steady, and give both the same space. Sculpt shows the vocal and the beat in one picture and marks in red where they clash, so you know where to cut.
How to make a vocal sit, step by step
- Set the level first: with the whole beat playing, bring the vocal up until every word is clear, then back off 1 dB. Check at a low volume too: if you can still follow the words, the level is right.
- Clean the vocal: high-pass the rumble (around 80 to 120 Hz) and cut a few dB where it sounds muddy or boxy, usually between 200 and 800 Hz.
- Make room in the beat: find where the beat covers the words, usually 2 to 5 kHz on the chords, synths or guitars, and cut it 2 to 3 dB with a wide band. A dynamic band does it only while the vocal is singing.
- Keep the level steady: compress so the quiet words don't drop under the beat (3 to 6 dB of gain reduction is a good start), and de-ess after it so the S's don't jump out.
- Put both in the same space: send the vocal and a little of the beat to the same short reverb or room, then check in mono and on phone speakers. If the vocal disappears there, go back to step 3.
Watch it explained: Vocal buried in the beat? Boost 2 to 5 kHz
Hear Sculpt
What you get with Sculpt
- Up to 24 bands: bell, shelves, tilt, notch, band pass, and low and high cuts from 6 to 96 dB/oct
- Dynamic EQ on any band: it only moves when the sound crosses the threshold, with an external sidechain too
- Live spectrum before and after, plus other Sculpt tracks and where they clash
- Grab a peak in the spectrum and a band lands right on it
- Each band on stereo, left, right, mid or side
- Zero latency, or linear phase in three resolutions for the master
- Listen to just what one band touches
- Auto gain for fair A/B, gain scale for the whole curve, undo and redo
- 57 presets for vocals, drums, instruments, mix bus and fixes
Questions
Why does my vocal sound like it's on top of the beat?
It's usually too loud, too dry or too bright compared with the beat. Bring it down a little, add a short reverb that the beat shares, and make room in the beat around 2 to 5 kHz instead of boosting the vocal there.
Why is my vocal buried even when it's loud?
Something in the beat is covering the same range, often pads, chords or a bright synth between 2 and 5 kHz. Cutting that range in those instruments helps more than making the vocal louder.
Should I sidechain the beat to the vocal?
It can help with a dense beat: a dynamic EQ band or a multiband compressor on the beat, keyed from the vocal, dips the 2 to 5 kHz range only while the singer is on. Keep it to 2 to 3 dB so the beat doesn't pump.
How loud should vocals be in a rap or pop mix?
There's no fixed number. In rap the vocal often sits a bit louder and drier, in pop it's loud but smoother. Compare with a song you like at the same loudness and match how clear the words are.
Free starter pack
2 plugins, free. Forever.
Toaster adds warm saturation and Overdo squashes and lifts every band, over the top. Make a free account and they're yours.
Get them free