Black Friday50% off every plugin · ends Tuesday 1 DecemberShop now →

Mastering beats

How to master a beat that still hits on a phone

Mastering a beat is mostly three things: a low end that holds together, a little glue, and a limiter that makes it loud without flattening the drums. Most beats that sound weak after mastering had a mix problem first, usually the kick and 808 fighting. Fix that, then master. Polish does the mastering part with one Loud knob and shows you how loud the beat really is.

No card needed for the trial. VST3 and AU, Mac and Windows. Pay once, use on 2 computers.

How to master a beat, step by step

  1. Fix the low end in the mix first: let either the kick or the 808 own the lowest notes (around 50 to 60 Hz), keep the 808 in mono, and make sure the kick and 808 don't hit the same spot at full level.
  2. Leave headroom: take any limiter off the master bus and bounce or play the beat with peaks around -6 dB.
  3. Glue it lightly: 1 to 2 dB of bus compression with a slow attack, so the kick and snare still punch through.
  4. Raise it into a limiter with the true peak ceiling at -1 dB. YouTube and Spotify turn everything down to about -14 LUFS, so going much louder than about -9 only squashes the drums. (In Polish: turn Loud, watch the meters, or press Hit target.)
  5. Check it on phone speakers and next to a beat you like at the same loudness. If the 808 disappears on the phone, add a little saturation to it in the mix so its upper harmonics carry.

Watch it explained: Bass disappears on phone speakers? Use saturation

Hear Polish

What you get with Polish

More about Polish →

Questions

How loud should a beat be?

There's no single number. Many trap and drill beats sit around -9 to -7 LUFS because producers like that dense sound, while YouTube and Spotify play everything at about -14 LUFS. If your beat only sounds better because it's louder, back off: it will be turned down anyway.

Should I master a beat before I sell or lease it?

For the version people hear on YouTube or BeatStars, yes, so it competes with other beats. Also keep an unmastered bounce and the stems: the artist's engineer will mix the vocals in and master the final song.

Why does my 808 vanish on phone speakers?

Phone speakers can't play the lowest notes, so a clean sine 808 almost disappears. Saturation adds higher harmonics that the phone can play, and your ear fills in the missing low note.

Do I need a mastering engineer for beats?

Not for most beats. A clean mix and a careful limiter get you most of the way. Save a mastering engineer for the songs that matter most, after the vocals are on.

Free starter pack

2 plugins, free. Forever.

Toaster adds warm saturation and Overdo squashes and lifts every band, over the top. Make a free account and they're yours.

Get them free
Psst… what's down there?