Loudness
How to make a mix louder without wrecking it
A mix gets louder when its peaks get smaller, not when you push the fader. The loudest parts, usually the kick, the 808 and sharp transients, hit the ceiling first, so a limiter can only turn the song up as far as those peaks allow. Control the low end, shave the peaks in small steps, then limit, and compare at the same loudness so louder doesn't fool you. Polish does the last part with one Loud knob and shows how loud the song really is.
How to make a mix louder, step by step
- Fix the low end first: the kick and bass eat most of the headroom. Keep the bass in mono, cut rumble under about 30 Hz, and don't let the kick and bass peak at the same moment at full level.
- Tame the loudest sounds in the mix: compress or clip the drums and the 808 a little on their own tracks, so a few hits don't decide how loud the whole song can get.
- Glue the mix bus lightly: 1 to 2 dB of compression with a slow attack evens it out without killing the punch.
- Shave the peaks in stages: a soft clipper taking 1 to 2 dB, then a true-peak limiter with the ceiling at -1 dB. Two small steps sound cleaner than one limiter working hard. (In Polish: Clip, then Limit, or just turn Loud.)
- Compare at equal loudness: turn the louder version down to match the original and listen again. If it only sounded better because it was louder, back off. Spotify and YouTube play everything at about -14 LUFS anyway.
Watch it explained: Louder always sounds better: level match before you compare
Hear Polish
What you get with Polish
- Six modules in a fixed mastering order: Tone, Glue, Width, Warmth, Clip, Limit, each with its own on/off
- True-peak limiter with lookahead and three styles: Clean, Punchy and Loud
- Loudness meters to the broadcast standard: integrated, short-term, momentary, range and true peak
- Targets for Spotify, Apple Music, YouTube, Deezer, loud and club masters, with what each platform will do to your song
- Hit target: Polish listens and sets Loud so your song lands on the target
- Compare at equal loudness, and Preview at the platform's level
- Glue on the whole mix or in three bands, mono bass, oversampled warmth and clipper
- 17 presets for rap, trap, pop, R&B, electronic and common fixes, plus A/B and undo
Questions
Why does my mix distort when I make it louder?
The limiter or clipper is working too hard on the biggest peaks, usually the kick and 808. Lower those in the mix, or spread the work over a clipper and a limiter, and stop before the drums lose their snap.
How loud should my mix be?
For streaming, around -14 to -9 LUFS integrated covers most music. Spotify and YouTube turn louder songs down to about -14, so going much louder only adds squash. Rap and EDM masters are often louder by choice.
Why is my mix quieter than songs on Spotify?
Pro songs are mastered: their peaks are controlled, so the whole song sits higher. Compare at the same loudness first; often the difference is the low end and the transients, not the master.
Should I make the mix loud before mastering?
No. Leave peaks around -6 dB and no limiter on the mix bus, so the mastering stage has room. Make it loud at the very end.
Free starter pack
2 plugins, free. Forever.
Toaster adds warm saturation and Overdo squashes and lifts every band, over the top. Make a free account and they're yours.
Get them free