Black Friday50% off every plugin · ends Tuesday 1 DecemberShop now →

Harsh vocals

How to fix harsh vocals without making them dull

Harsh vocals almost always come from a few narrow spots between 2 and 6 kHz that jump out on certain notes and words, plus loud S's higher up. A wide EQ cut fixes the harshness but takes the clarity with it. The cleaner fix is to turn down only those spots, only while they ring. That's what Hush does: it finds them by itself as the vocal moves and leaves the rest as bright as it was.

No card needed for the trial. VST3 and AU, Mac and Windows. Pay once, use on 2 computers.

How to fix a harsh vocal, step by step

  1. Check the cause first: a cheap mic, a bare room, singing close or a lot of compression all make a vocal harsher. Re-recording or using less compression is sometimes the real fix.
  2. Find the spot: play the harsh part and sweep a narrow EQ boost between 2 and 6 kHz. Where it hurts most is your problem. Cut it 2 to 4 dB with a narrow band, or make the band dynamic so it only moves on the harsh notes.
  3. If the spot moves from note to note, use a resonance suppressor instead. In Hush, start from Vocal Smoother (or Rap Vocal Clean), turn Depth until it's clearly too much, then back off.
  4. Handle the S's on their own, between about 5 and 10 kHz, with a de-esser or Hush's De-Ess Soft preset. Then add any brightness or air you want after that, not before.
  5. Press Delta in Hush to hear only what it takes away (thin ringing, not the voice), then bypass at the same loudness and listen in the mix. It should sound smoother, not darker or further away.

Watch it explained: Sound harsh and you can't tell why? Tame the resonances

Hear Hush

What you get with Hush

More about Hush →

Questions

What frequency makes vocals harsh?

Usually somewhere between 2 and 6 kHz, where our ears are most sensitive. S sounds sit higher, around 5 to 10 kHz. The exact spot depends on the voice and the mic, so find it by sweeping a narrow boost and listening.

Why do my vocals sound harsh after compression?

A compressor turns the loud parts down and brings everything else up, including the bright edge of the voice and the S's. A faster attack and less gain reduction help, or tame the harsh spots before the compressor and de-ess after it.

Should I just turn the treble down?

Usually not. A wide high cut makes the whole vocal dull and pushes it back in the mix. Cutting only the harsh spots, only when they happen, keeps the words clear.

De-esser or resonance suppressor for harsh vocals?

A de-esser is for the S's. A resonance suppressor handles harshness anywhere, including the 2 to 6 kHz edge that moves with the melody. Many mixes use both, with the suppressor first.

Free starter pack

2 plugins, free. Forever.

Toaster adds warm saturation and Overdo squashes and lifts every band, over the top. Make a free account and they're yours.

Get them free
Psst… what's down there?