Vocal EQ
How to EQ vocals: cut first, then boost
Most vocals need the same few moves: a low cut for rumble, a small cut where it sounds muddy or boxy, a little presence so the words come through, and maybe some air on top. Cut narrow, boost wide, and listen in the mix, not alone. Sculpt shows the vocal as a live picture, so you can see where it piles up and drag a band right onto it.
How to EQ a vocal, step by step
- High-pass the rumble: start around 80 Hz for male voices and 100 to 120 Hz for female voices, then move it up until the voice gets thin and back off a little.
- Cut mud and boxiness: sweep a narrow boost between 200 and 800 Hz, find the spot that sounds muddy (lower) or like a cardboard box (higher), and cut it 2 to 4 dB.
- Bring the words forward: if the vocal sits behind the beat, a wide boost of 1 to 3 dB between 2 and 5 kHz helps it cut through. If it's harsh there instead, cut, don't boost.
- Add air only if it needs it: a gentle high shelf from about 10 kHz adds shine. Do it after de-essing, or the S's get louder too.
- Use a dynamic band for problems that come and go, like a harsh note or a boomy word, so the EQ only moves when it happens. Then bypass at the same loudness and listen in the mix.
Watch it explained: Vocal sounds boxy? Cut 400 to 800 Hz
Hear Sculpt
What you get with Sculpt
- Up to 24 bands: bell, shelves, tilt, notch, band pass, and low and high cuts from 6 to 96 dB/oct
- Dynamic EQ on any band: it only moves when the sound crosses the threshold, with an external sidechain too
- Live spectrum before and after, plus other Sculpt tracks and where they clash
- Grab a peak in the spectrum and a band lands right on it
- Each band on stereo, left, right, mid or side
- Zero latency, or linear phase in three resolutions for the master
- Listen to just what one band touches
- Auto gain for fair A/B, gain scale for the whole curve, undo and redo
- 57 presets for vocals, drums, instruments, mix bus and fixes
Questions
Should I EQ vocals before or after compression?
Cut before the compressor, so it doesn't react to rumble and mud. Boosts like presence and air often sound smoother after it. A common chain is EQ cuts, compressor, de-esser, then a gentle EQ boost.
What frequency makes vocals clearer?
Clarity mostly comes from cutting mud between 200 and 500 Hz. After that, a small, wide boost between 2 and 5 kHz brings the words forward. Boosting without the cut usually just makes the vocal louder and harsher.
Why does my vocal sound boxy or nasal?
Boxy is usually a build-up around 400 to 800 Hz, often from a small room. Nasal sits higher, around 1 to 1.5 kHz. Find the exact spot with a narrow boost sweep, then cut it a few dB.
Should I EQ the vocal solo or in the mix?
Find problems solo, but make the final moves with the beat playing. A vocal that sounds thin on its own often sits perfectly in a full mix.
Free starter pack
2 plugins, free. Forever.
Toaster adds warm saturation and Overdo squashes and lifts every band, over the top. Make a free account and they're yours.
Get them free